Diesin Of A Narrow Long Private House Yard
A great place of rest for the whole family in a private house courtyard can be built by hand. In this case, it will be a small bench and a place to store the floors. It's only a couple of days.
Materials
For a garden bench with your hands, prepare:
• A piece of fixture;
cheek;
• Sand;
• Bulk;
• Wooden poles;
:: Wooden raids;
• Cement;
• rifles;
• Level
• Blade;
∙ Garden car;
:: rubber hammer;
• Drella.
Step 1. To begin with, it is necessary to prepare a place for the creation of a coma. In the center, you'll get him into the ground with a piece of the fixture and pull a line from him. Equate the level of the hotbed and dig up a little deeper for subsequent decoration. When the foundation is established, check the level.
Step 2. In excavated depression, send a layer of cheek around 7 cm thick.
Step 3. Sand on the top of the cheek. The thickness of this layer should be about 10 cm.
Step 4. Put the balds around the corner. First, put some lanes along the radius and check the level. These lanes will guide you in laying the other stones. Put them on the basis and level them with rubber hammers.
Step 5. Put the rest of the balds down from the center to the edges. Don't sleep stitches at this stage. Check the level of the podium and if it's all right, just put your stitches down.
Step 6. Squares fall asleep as follows: at the beginning, just dry sand falls asleep, and after it needs to be filled with water, repeat this procedure until the stitches are tightly closed.
Step 7. It is now possible to start making bench around the corner. It will consist of 4 parts, which will require 10 wooden, polyurethane poles, a size of 100 x 100 mm and a height of about metre. This bench will be about 40 cm high. The poles need to dig holes, put poles in them, and if you want to strengthen that base with cement, pour it into the holes.
Step 8. The same polyurethane board for the bench seat shall be fitted with parallel lines on the poles using two rifles at the end of each raid. Make the fronts on the side of the bench. Smash them also with rifles.
Step 9. In order to equitably place cross-sectional raids on the bench, reuse the corn machine inside the bench. Put a long wooden raid on it and use it to check the correct location of cross-sectional rivers.
Step 10. In order to build cross-sectional rivers, make openings and attach them to the base of the bench of non-removable rifles.
